The 1 roller glue spreader mod. SCB1/82 is suitable for every type of spreading on edges and solid, with any kind of glue, in an accurate and uniform manner.
The introduction of the piece to be glued is manual with idle support piece rollers at entry, and idle grooved rollers at exit.

Spreading roller covered in antiacid rubber, ground and furrowed, hard wearing, as they are built with a rational layer of rubber it is therefore possible to carry out 6-7 grindings.
It is easy and quick to disassemble.

Uniform dosing of the glue by a ground distribution vat, in stainless steel, of quick extraction for easy cleaning.

Tank holder of the glue and roller washing water, in galvanized sheet-iron, extractible for easy cleaning.

Electrical installation and control panel by magnethermic switch, with stopping bobbing, “on-off” switch.

Optional on request, idle roller in rubber adjustable in height from 0 to 200 mm with relative safety switch. Double fenced piece guide (entrance-exit), adjustable for the whole lenght of the spreading roller.

Mod. SCB1/82 TA in addition to the characteristics of the mod. SCB1/82, it has a motorized 2 mt. set of rollers at the entrance and exit..